Car Sound Deadener Butyl Rubber Heat Insulation 34pcs 400x250mm
- Product label: Sold out
0Low stock
0In stock, ready to ship
Couldn't load pickup availability
Get notified by email when this product becomes available
Have a question?
Description
-
Made of butyl material for heat resistance.This material eliminates vibrations, reduces general noise and rattle of the vehicle allowing for higher comfort.
-
Self-adhesive sound dampening material,it is easy to install.
-
It is desined in handy size which make it easier in terms of cutting.
-
Block transmit sunlight, engine, exhaust pipe heat to the cab, reduce air conditioning energy consumption.
-
Color: Black
-
Material: Butyl Rubber, Aluminum
-
Total Coverage Area: 25 sqft
-
Thickness: 2mm / 0.08 inch / 80 mil
-
Size: 600x400mm / 23.62''x15.75''(L*W)
-
Decide what part you want to insulate first: car roof,car floor,car doors or a hood.
-
Remove the remains of the factory insulation once you have dismantled the interior.Properly clean and degrease the surface prior to installation of mat.
-
Measure the pre-cleaned surface of the prospective spot that you are going to treat.
-
Try to locate the piece of material onto the prospective surface of a car without removing an adhesive paper.When your sheet is ready to used,lay that down to the surface and let is glue.Flatten the sheet with hands to avoid air bubbles.Use a roller for rolling down the foil as a neat step.
-
Please clean the surface you want to paste.
-
You could heat with a hair dryer to make it soft,then compacted by hand.If the room temperature is below 5 degrees Celsius first with lamp heating it until soft.
-
It would be best to wear the gloves when working.
-
10 x Heat Sound Deadener Insulation Mat
-
1 x Manual